So hab nen geilen Mod im UCPSB gefunden. Schaut ihn euch mal an. Habs nicht übersetzt da ich keine Zeit hatte.
ORIGINALTEXT:
Materials Needed:
1 Papermate Profile
1 Pilot G2
Hacksaw
File or sanding instrument
Step 1:
Disassemble both pens, leaving you parts like this, discard the back piece of the profile and the spring from the profile.
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0442.jpg[/img]
Step 2:
Cut the tip completely off the profile leaving you with this...
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0443.jpg[/img]
Step 3:
Cut your G2 barrel so that the threads are gone, while at this you can break the clip off of your G2...
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0444.jpg[/img]
Step 4:
Sand down the Profile barrel so that the G2 barrel fits over, like MMX... (this takes a bit of time)
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0445.jpg[/img]
Step 5:
Take the front end of the G2, and sand down the little bump before the grip, you may have to slide the grip down a bit to get at it easier...
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0446.jpg[/img]
Step 6:
Put the normal G2 ink cartridge in the G2 as it normally is.
Step 7:
Clean out the profile ink tube, take off the tip and blow INTO A SINK OR GARBAGE!!!
run some water through it so its clean for less mess, then cut
6.1 cm out of the ink tube like this...
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0449.jpg[/img]
Now put it down the profile body so that its in the back where the G2 part is...
Step 8:
Cut a strip off of your profile grip, or use another method for this step. All your doing here is making it so the G2 front stays in the Profile body better, and works as a shock absorbant device. Put the front part of the G2 into the Profile body all the way up to that little bump, so the grip is flush (even with) the Profile body.
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0447.jpg[/img]
Step 9:
Add part of the Profile grip (length is your choice) to the back of the G2, and also to the front if you'd like but i did not...
Finished
[img]
http://i25.photobucket.com/albums/c84/m ... 0_0441.jpg[/img]
Specs:
Length-19.8 cm
COP- close to center
Weight - MX < Profile G2
Pros:
Retractable!
Balanced
Durable
Uses Profile!!!! for something other than the grip.
Only takes 2 pens to make ( $2.00 USD) if the pens were sold seperately.
Cons:
Body changes shape a little.
Time consuming to make (cutting and sanding)
Inserts???