Deswegen stelle ich meine Frage einfach mal so, hat jemand oder kennt jemand dir benötigenden Pens und das Tutorial zu dem Mod? Ich hab nur was auf japanisch oder französisch gefunden... Und Google sagt bullshit wenn ich es übersetzten will, außerdem wollte ich die Daten des pens wissen? Oder hat vielleicht jemand hier einen abzugeben?
Wenn ich mich jetzt entschuldigen darf... Ich fahre nach Hause und bekomme einen Herzinfarkt. HAL Fan Mesi Fan
2 old supertips
2 KT type caps
2 Dr. Grips
2 air blancs
1 hyperjell
a few anyball rings
1 round stic grip
2 airfit rings (that silver thing) and 2 g3 rubbers (that thing in the g3 cap) (both not necessary, but nice to have)
tape
how to:
1. remove backplug, ink and the front part of the supertip, so you only have the body left (do this with both bodies)
2. make a hole in the KT cap, so you can put the tips in there (just as you would do with a seven watercolor)
stick the 2 supertip bodies together with the round stic grip. cut the supertips in about 6.2cm each. the finished mod will be about 20cm then
3. put the airblanc tips into the dr grip tip, might be helpful to use glue here
4. cut 4 parts of 5mm hyperjell grip
5. put two of those 5mm hyperjell grips on each one of the airblanc tips. hard to explain without pictures, but it says the airblanc tips stick out of the dr grip tip.
you're supposed to put 5mm hyperjell grip on the part sticking out and then put another 5mm over those 5mm.
6. put the airfit silver ring over the hyperjell grips from 5. (not necesarry)
7. put the tip part you just made in the KT cap, dr grip tip pointed inverse
8. stabilize with tape
9. put the caps on the body
10. attach a few anyball rings at both ends
11. put that g3 rubber into the airblanc tips and tape the caps for nice godtier design
thats about it, a few parts are not easy to understand without pictures.
i would make one myself, but i dont have any airblanc tips ._.