German Penspinning Community Forum

hknl13 hat geschrieben:http://img521.imageshack.us/img521/1812/dscn1761bh6.jpg
it is very expensive to make and requires many parts

weight: about 24 g
length: about 19.5 cm

Parts:
G.J.H.×1
Hybrid Gel grip x2
new HGR×3
ail-blanc×1
signo×1
Dr.Grip G-SPEC×1(center of Gravity)

1. The grip of the air blanc that divided equally it 4,5 it covers the HGG that attached to 1.G.J.H. from base.This is very hard and will consume much of your time trying to get it on. Put 2 tips of HGR on top of the tip of GJH front

**The air-blanc grip is used to cover the HGG grip on the GJH all the way to the 2 HGR grips on front. The order of the tips is as follows: GJH > HGG > HGR > HGR. This will be the most difficult step because the air-blanc grip will not slide over the HGG grip easily. (It is recommended you use rubbing alcohol to lubricate the air-blanc grip to make it easier to get it on....even then it's still going to be very tough) -K4S**

2.The tip of HGR on the GJH is held with glue and Scotch tape

**Hotglue/superglue or teflon tape can be used -K4S**

http://img521.imageshack.us/img521/6687/dscn1762rh7.jpg

3. Because there is lots of grip showing, place another grip on top of the ail-blanc grip to cover the tip parts

**Add a grip of your choice (eg. profile/anyball) to the front on top of the air-blanc grips to cover the tips. Adding grip on the other side of the HGG grip (on the GJH body) is optional. -K4S**

http://img521.imageshack.us/img521/922/dscn1763bo3.jpg


4. In the cap of the G3 place 3 more tips in this order: signo first → HGR second → HGG third and fit Dr. Grip G-SPEC grip in.
]http://img521.imageshack.us/img521/6745/dscn1764eq6.jpg


5.Cut part of the HGG grip and place it on the cap, cover the HGG grip over with the G-SPEC grip.
http://img521.imageshack.us/img521/745/dscn1765ba3.jpg

6. the cap is attached to the pen top

Finished~